Control M Gas External

1(4)
DATA SHEET
Gas Alarm Panel Module
Control M Gas
External
Part no. 5103001-00A
System: Salwico Gas Detection, Salwico Gas Sampling
General Description
Data
The Control M Gas is a control panel with a 4.3"
graphical colour display used to manage and
supervise a gas alarm system. Control M Gas
External can be mounted on any flat surface or
flush mounted, independently from a gas alarm
cabinet.
Operating voltage range 22-48 VDC
Control M Gas External is equipped with
communication buses for connecting to the
system via BBE interface RS-485 or BBE interface
PB-485.
Features:
• A backlit 4.3" graphical colour display
• Alarm buzzer
• LED status indicators
• Backbone Bus Interface RS-485
• Backbone Bus Interface PB-485 (Power Boost
loop)
Current consumption
(at 24V)
92 mA
Ingress protection
IP55
Operating temperature
range
-5°C to +55°C
Weight
620 g
Display
4.3", 480×272 pixels, TFT
USB port
USB 1.1 Embedded Host
RS-485 interface
Isolated
2 digital inputs
24 VDC, open circuit
supervision
3 digital outputs
24 VDC max. 40 mA , no
supervision
Indicators and Buttons
• USB interface (for service & maintenance)
• Two configurable inputs
• Three programmable outputs
Refer to the User Guide for more information on
operating Control M Gas.
For details on assembling a system and definitions
of common system terms, refer to the Installation
Manual.
Refer to the User Guide for more information.
Addressing
Available addresses for Control M Gas External
are between 1 and 10.
As a system master controller it must have
address 1.
The specifications described herein are subject to change without notice.
Data sheet no. 5103001-00A Control M Gas External.12 2.ME
www.consilium.se
DATA SHEET
2(4)
Terminals
Connections
Control M Gas External mounts outside of the
central.
Using ribbon cables connect the Control M Gas
to Terminal M Gas.
Figure 1. Control M Gas connected to Terminal M Gas
The specifications described herein are subject to change without notice.
Data sheet no. 5103001-00A Control M Gas External.12 2.ME
www.consilium.se
3(4)
DATA SHEET
RS-485 Termination
Table 1. DIP switch for RS-485 Termination
For RS-485 Termination the built-in terminator
(120 ohm) can be activated with the RS-485 DIP
switch located on the rear of the front panel.
DIP
Switch
No.
Description
ON
OFF
For recommendations and examples on RS-485
Termination, refer to the Installation Manual.
1
BBE1
Active
Deactivated
2
BBE2
Active
Deactivated
Module Dimensions (mm)
* Knockouts
** Mounting holes for wall mount
*** Mounting holes for inset
The specifications described herein are subject to change without notice.
Data sheet no. 5103001-00A Control M Gas External.12 2.ME
www.consilium.se
DATA SHEET
4(4)
Mounting Dimensions (mm)
The specifications described herein are subject to change without notice.
Data sheet no. 5103001-00A Control M Gas External.12 2.ME
www.consilium.se