Adhesive 468MP Transfer Tape

SPECIFICATION
468MP ADHESIVE
Description
468MP is a firm acrylic pressure sensitive adhesive system. It features high ultimate bond strength with
excellent high temperature performance and excellent solvent resistance.
Bond strength increases substantially with natural ageing. 468MP is a long ageing and resistant product used
extensively by the nameplate industry.
Physical Properties
Adhesive Type:
Firm Acrylic
Thickness
Tape:
Liner:
130 µm
100 µm
Release Liner:
Tan printed polycoated paper.
Tape Colour:
Clear
Shelf Life:
12 months from date of despatch when stored at 21°C (70°F) & 50% relative
humidity.
5 Thou
Performance Characteristics
Adhesion to Stainless Steel:
7.6 N/10mm
Shear Resistance:
High
Temperature Performance
Max: Minutes / Hours:
Max: Days / Weeks:
Minimum:
204°C
149°C
-30°C
Solvent Resistance:
Excellent, When the adhesive is properly applied to impervious materials, it
will resist solvent attack and adhesive softening through edge contact with mild
acids, alkalines, oils, grease, gasoline kerosene, JP-4 fuel and many other
standard aromatic and aliphatic solvents. However it is not recommended for
Uses where continuos immersion is required.
U.V Light Resistance:
Excellent, Will not oxidise when exposed to air or sunlight UV.
Water Resistance:
Excellent, There are no evident adverse effects on the bond of properly applied
materials after immersion in 21°C water for about 100 hours.
This specifications are based on information supplied to us from a reliable source
Additional Product Information
468MP is designed with a moisture resistant release liner which resists cockling or wrinkling from high
humidity. The 130-micron thick adhesive is ideally suited for joining materials that are relatively rough or thick
materials with a small degree of residual stress. The peel strength of 468MP is typically 30% higher than the 50micron thick adhesive when measured on the same flat surface. It can be many times higher on embossed or
textured surfaces.
Application Techniques
•
Bond strength is dependent upon the amount of adhesive-to-surface contact developed. Firm application
pressure develops better adhesive contact on thus improves bond strength.
•
To obtain optimum adhesion, the bonding surfaces must be clean dry and well unified. A typical surface
cleaning solvent is isopropyl alcohol and water. Use proper safety precautions for handling solvents.
•
Ideal tape application temperature range is 21°C to 38°C (70°F to 100°F), Initial tape application to
surfaces at temperatures below 10°C (50°F) is not recommended because the adhesive becomes too firm to
adhere readily. However once properly applied low temperature holding is generally satisfactory.
Applications
468MP is well suited for bonding together a wide variety of similar and dissimilar materials such as metals,
paints, wood, glass and some plastics.
An excellent adhesive for mounting nameplates and decorative trim.
Miscellaneous joining and holding where a thin, long ageing bond is required.
Automotive Industry.
Specifications
This tape meets the requirements of U.S government specifications MIL-P-19834, Amendment 1, Type 1.
468MP is a UL and AGA recognised product.
This specifications are based on information supplied to us from a reliable source